profiler - Man Page

package require Tcl  8.3

package require profiler  ?0.6?

::profiler::init

::profiler::dump pattern

::profiler::print ?pattern?

::profiler::reset ?pattern?

::profiler::suspend ?pattern?

::profiler::resume ?pattern?

::profiler::new-disabled

::profiler::new-enabled

::profiler::sortFunctions key

The profiler package provides a simple Tcl source code profiler.  It is a function-level profiler; that is, it collects only function-level information, not the more detailed line-level information.  It operates by redefining the Tcl proc command. Profiling is initiated via the ::profiler::init command.

::profiler::init

Initiate profiling.  All procedures created after this command is called will be profiled.  To profile an entire application, this command must be called before any other commands.

::profiler::dump pattern

Dump profiling information for the all functions matching pattern.  If no pattern is specified, information for all functions will be returned.  The result is a list of key/value pairs that maps function names to information about that function.  The information about each function is in turn a list of key/value pairs. The keys used and their values are:

totalCalls

The total number of times functionName was called.

callerDist

A list of key/value pairs mapping each calling function that called functionName to the number of times it called functionName.

compileTime

The runtime, in clock clicks, of functionName the first time that it was called.

totalRuntime

The sum of the runtimes of all calls of functionName.

averageRuntime

Average runtime of functionName.

descendantTime

Sum of the time spent in descendants of functionName.

averageDescendantTime

Average time spent in descendants of functionName.

::profiler::print ?pattern?

Print profiling information for all functions matching pattern. If no pattern is specified, information about all functions will be displayed.  The return result is a human readable display of the profiling information.

::profiler::reset ?pattern?

Reset profiling information for all functions matching pattern. If no pattern is specified, information will be reset for all functions.

::profiler::suspend ?pattern?

Suspend profiling for all functions matching pattern.  If no pattern is specified, profiling will be suspended for all functions. It stops gathering profiling information after this command is issued. However, it does not erase any profiling information that has been gathered previously.  Use resume command to re-enable profiling.

::profiler::resume ?pattern?

Resume profiling for all functions matching pattern.  If no pattern is specified, profiling will be resumed for all functions. This command should be invoked after suspending the profiler in the code.

::profiler::new-disabled

Change the initial profiling state for new procedures. Invoking this command disables profiling for all procedures created after this command until new-enabled is invoked. Activate profiling of specific procedures via resume.

::profiler::new-enabled

Change the initial profiling state for new procedures. Invoking this command enables profiling for all procedures created after this command until new-disabled is invoked. Prevent profiling of specific procedures via suspend.

::profiler::sortFunctions key

Return a list of functions sorted by a particular profiling statistic. Supported values for key are: calls, exclusiveTime, compileTime, nonCompileTime, totalRuntime, avgExclusiveTime, and avgRuntime.  The return result is a list of lists, where each sublist consists of a function name and the value of key for that function.

This document, and the package it describes, will undoubtedly contain bugs and other problems. Please report such in the category profiler of the Tcllib Trackers [http://core.tcl.tk/tcllib/reportlist]. Please also report any ideas for enhancements you may have for either package and/or documentation.

When proposing code changes, please provide unified diffs, i.e the output of diff -u.

Note further that attachments are strongly preferred over inlined patches. Attachments can be made by going to the Edit form of the ticket immediately after its creation, and then using the left-most button in the secondary navigation bar.

performance, profile, speed

Programming tools