uhd_siggen_gui - Man Page

uhd_siggen_gui: [options]

GUI to allow UHD supported hardware to be a signal generator.

-h,  --help

show this help message and exit

-a ARGS, --args=ARGS

UHD device address args , [default=]

--spec=SPEC

Subdevice of UHD device where appropriate

-A ANTENNA, --antenna=ANTENNA

select Rx Antenna where appropriate

-s SAMP_RATE, --samp-rate=SAMP_RATE

set sample rate (bandwidth) [default=1000000.0]

-g GAIN, --gain=GAIN

set gain in dB (default is midpoint)

-f FREQ, --tx-freq=FREQ

Set carrier frequency to FREQ [default=mid-point]

-x WAVEFORM_FREQ, --waveform-freq=WAVEFORM_FREQ

Set baseband waveform frequency to FREQ [default=0]

-y WAVEFORM2_FREQ, --waveform2-freq=WAVEFORM2_FREQ

Set 2nd waveform frequency to FREQ [default=none]

--sine

Generate a carrier modulated by a complex sine wave

--const

Generate a constant carrier

--offset=OFFSET

Set waveform phase offset to OFFSET [default=0]

--gaussian

Generate Gaussian random output

--uniform

Generate Uniform random output

--2tone

Generate Two Tone signal for IMD testing

--sweep

Generate a swept sine wave

--amplitude=AMPL

Set output amplitude to AMPL (0.0-1.0) [default=0.15]

-v,  --verbose

Use verbose console output [default=False]

uhd_siggen(1)

dial_tone(1), tags_demo(1), uhd_fft(1), uhd_rx_cfile(1), uhd_rx_nogui(1), uhd_siggen(1).